TITLE3.jpg

How To Measure Correct Trail

Home
What's New?
Un-Club
Rides & Events
Interactive Forum
Biker Rights
Ride Review
Photo Album
Product Review
Monkey Wrench
Roadhouse Graffiti
Road Tunes
Pit Stops
Member Roster
Meet-A-Monkey
Gorilla Grill
Dear Ms. Monkey
Fun House
Web Surf'n
Roadhouse Rags
Bulletin Board
Archive
Contact Us
Spark Plug, Spinning
trailweb.jpg
(click to enlarge)

How To Measure Correct Trail

Using a tape measure, or if not available a piece of string, raise the bike to upright position. Start by holding the tape measure straight down from the front axle to the floor. Put a mark on the floor at that point. Then, place the tape parallel to the steering axle, following the angle of the steering head all the way down to the floor. Put a mark here too. Now all you have to do is to measure the distance between the two marks and you have your trail figure. It should read between 2 and 4 inches.

* Note: If your bike is equipped with rear suspension, have someone sit on the seat when you make these measurements, to simulate your actual riding conditions.

Too Little Trail
With too little and extreme cases negative trail, (steering axle mark behind the front axle mark), the bike will handle with unbelievable ease at low speeds, but be completely out of balance at high speed. It will easily develop a fatal high-speed wobble. Extremely dangerous!

 

Normal Trail
Somewhere between 2 to 4 inches the bike will handle easily at both high and low speeds. Flowing smoothly through curves without swaying or wobbling. If you use a very fat rear tire, you should keep the trail as close to 4 inches as possible. A slightly large trail is also practical for touring.

Too Much Trail
If the trail is more than 4 inches the bike will handle sluggishly at high speeds. It will seem almost too steady. You will have trouble balancing your bike at lower speeds, or on winding roads. It will feel generally sluggish and clumsy.

 

hanging The Center of Gravity
To make full use of your triple trees you should also readjust the fork when your bike's center of gravity changes, like when you are packing a lot of luggage.

If the center of gravity is too low, you will have good maneuverability around curves, but the stability when you are going in a straight line will suffer. If the center of gravity is too high, it will be the other way around. Always readjust the triple trees within the sensible limits of trail, as riding conditions change. This way you will always be able to use your bikes handling resources to the maximum. The adjustable triple trees are designed to give you the best possible handling at all times. So make use of them!

Submitted By: Dennis' Auto Service

Enter content here

Enter content here

Horizontal Divider 16
-Roadhouse Monkeys Forever-

*The rides that we have been and hope to be enjoying in the future are totally informal and open to all. You are free to invite your friends and associates making clear to them that we are not a club or organization but simply fellow motorcycle enthusiasts who utilizing listed e-mail addresses to suggest and participate in enjoyable rides. You are encouraged to utilize this web site to suggest your own rides.